Tile Expansion Joint Detail

The sealant used in expansion joints should achieve a minimum shore a hardness of 35.

Tile expansion joint detail.

Where should movement joints be placed. A movement joint is in the tile only. It s quite common to see controlled breaks in concrete and those are usually expansion joints. If you tile over an expansion joint then you need to honor that joint in the tile as well.

Expansion joints are created in the concrete to compensate for excessive expansion due primarily to temperature changes in the concrete. Movement joints are an integral part of any tile assembly and must be incorporated within the tile field at doorsills and at transitions to walls and other restraining structures to allow movement of the assembly and prevent stresses that can damage the system. The tcna handbook recommends allowing for expansion and contraction in every tile installation. Recognizing that tile is a facade movement joints are needed to eliminate stresses that can occur between the substrate and the tile due to differing amounts of expansion and contraction.

It is best to achieve a two sided bond only to the flanks of the open joint in the tile. Schluter systems prefabricated movement joint profiles protect tile edges and prevent sound bridges and surface water penetration resulting in a permanent maintenance free installation. Latasil or urethane sealant placed over a closed cell foam backer rod. It allows for movement in the tile.

An expansion joint is in the substrate for instance in concrete. Joints in the tile assembly will result in callbacks and expensive repairs as well as the subsequent installation of movement joints.